Support for different hardware (SMART-L-V2.1, two controller boards equipped with STM32F103C8T6)

[andishock]

Hello folks,
I know this firmware supports only the hardware consisting of the single mainboard controlling both of the hoverboard motors. I just wonder, if anybody around here stumbled over a different kind of hardware consisting of two identical controller boards each equipped with a STM32F103C8T6. There is a printing "SMART-L-V2.1" onto it. The pins for the JTAG/SWD connectors I soldered myself, so don't worry about that.
Does anybody know about some custom firmware supporting this kind of hardware?
Thank you!

[Candas1]

Hi,

Have you checked this

[andishock]

Hi,
Thanks for our answer!
Yes, I already checked for similar boards out there, but none of them seems to be compatible to the hardware I found.

[Candas1]

Actually in the meantime I found out the split board firmware is not working on STM32F103C8T6, someone would need to port it.

[Candas1]

This new port might be the right place to start:
https://github.com/JohMah/Hoverboard-JC2015.7.31.V2.0-Hack

The board looks different so pin mapping would have to be checked, but at least the chip looks compatible.

[L1mp4]

Hi! Did you find anything simple to make this run like you want it? Thanks!

[zimmii91]

hi ! i got the same board, in 2 hovers actually. any luck on programming?

[I-hate-2FA]

so far no gen2 f103 support on any firmware yet other then the ones modified from gen1, but i am working on porting mine to f103