-
Notifications
You must be signed in to change notification settings - Fork 36
Home
HomeKid edited this page Sep 6, 2019
·
20 revisions
- WS2812B LEDs are have much higher power usage over a certain distance - 18 Watts max (~3.5 Amps @ 5V for 60 LED / meter strips) per meter! The max rating is assuming all the LEDs are on full white, usually the actual current for colorful design is about 1/3 to 1/2 the max current. A good power supply such as a 5V 10A supply is key! For 5 meters of 30 LED/meter strip the recommended power supply is DC5V 10A!
-
Maximum number of LEDs are limited to 300 LEDs. This could be 10 meters of length using 30 LED/meter WS2812B strips. Below that number any length everything should work properly!
- This code provides a reset solution. If something goes wrong, You can reset the module to factory settings! The Wi-Fi and HomeKit configuration will be reseted. Single pressing the button will turn the LED ON / OFF. Visit Setup page for more information.
- The WS2812B i2s library uses hardware I2S, so output pin is
GPIO3and cannot be changed. On some ESP8266 such as the Wemos D1 mini,GPIO3is the same pin used for serial comms.