Enabling M48 Z_MIN_PROBE_REPEATABILITY_TEST In Precompiled FW

[Ramrawd]

I've given a go at compiling my own firmware but I fully admit that it's above my skill level at the moment.

With that said, would it be possible to enable the M48 command for doing a repeatability test using a BLtouch in the precompiled firmwares?

More info about the command can be found here: https://marlinfw.org/docs/gcode/M048.html

I'd like to figure out how accurate my probe really is!

Thanks!

[Schnabulation]

Just to add: I have enabled this in my own config of this firmware and it works flawlessly...

[Schnabulation]

I mean you asked for the M48 command to be added to the firmware, so you should know how to use it. We are not your personal support...

[darco415]

I mean you asked for the M48 command to be added to the firmware, so you should know how to use it. We are not your personal support...

No the OP did.....my question was just on interpretation. Are you affiliated with this fw or just a troll?

[Jyers]

Okay guys, chill. No pointless arguing in some random discussion.

[darco415]

Okay guys, chill. No pointless arguing in some random discussion.

sorry boss

[Schnabulation]

Okay guys, chill. No pointless arguing in some random discussion.

Sorry, you are right...

There are a bunch of info regarding the BL Touch repeatability test. But basically you wanna look at „standard deviation“ - it means how far off the probe was between the different probings. The lower the better - your value is fine for an original BL Touch.

[Jyers]

I don't see any reason not to enable this functionality. I'll add it to the next release :)

[Ramrawd]

Excellent! Thank you so much for your time!