README.adoc

BlueSCSI

BlueSCSI & ArdSCSino are hardware that reproduces SCSI devices (hard disks) with an Arduino STM32F103C (aka Blue Pill.)

BlueSCSI created by erichelgeson is a fork of ArdSCSino-stm32 which adds:

• Usability Improvements

• Mac specific functionality

• Enable/Disable Passive SCSI termination

• An alternative power source if not able to be powered by the SCSI bus

• Documentation

• Open Hardware (KiCad & Grebers)

ArdSCSino-stm32 created by ztto is the STM32 version of ArdSCSino

ArdSCSino created by Tambo (TNB Seisakusho)

Join us in #bluescsi on Discord or open an issue on this repo.

Table of Contents

• Compatibility
  • Compatible
• Performance
• Assembly
• Usage
  • Termination
• Troubleshooting
  • Older Version Specific Troubleshooting
• Hardware Versions
  • 1.1-a (Latest)
  • 1.0-c
  • 1.0-b
• Development (Advanced)
• Notes
  • Making Gerbers for JLCPCB

Compatibility

If your computer is not listed below - it may be compatible but there is no guarantee it will work. This device is designed and tested to work with pre-PowerPC Macs.

Compatible

Supported-Systems

Performance

Performance

Assembly

See docs/assembly.md

Usage

Usage

Termination

To enable termination place the two jumpers on the TERM block. Termination should be enabled if it is the last device in the SCSI chain, otherwise remove the jumpers if it is not.

Troubleshooting

https://github.com/erichelgeson/BlueSCSI/wiki/Troubleshooting

Older Version Specific Troubleshooting

Version 1.0-b

Hardware Versions

1.1-a (Latest)

1.1-a Desktop

• Binky! There are now resistors and pin outs for Power and Activity LED’s

• Resistor nets flipped all the same way

• 50 pin allows for right angle connector

• SD Card facing out the back - gives some better options for mounting and access

• New bracket that uses less filament and has mounting options for most cases

• Better mounting holes on the PCB

• New artwork by @Stephen

1.1-a DB25

• Plugs directly into the DB25 port of your Mac.

• Removed unnecessary components.

• Termination is always on.

• If you do not need termination you can socket or not install the resistor nets (this would be an unusual case)

1.0-c

• Fixed issue with diode footprint being too small

• Fixed issue with external power and TERMPOWER

1.0-b

First release

Development (Advanced)

Flashing

Notes

Making Gerbers for JLCPCB

https://support.jlcpcb.com/article/44-how-to-export-kicad-pcb-to-gerber-files

BlueSCSI™ - Eric Helgeson - All rights reserved.