You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
very much like 2.0 but hall pins need different ordering !
Has a third led header, 3pin with the middle pin being controlled by PB5, right pin is simply blinking.
Warning: both 3pin led header pull down from battery voltage! 4pin led header pulls down from the usual 14V
The usual second serial port to the left of the St-Link flash header is only PB4 on both middle pins.
USART0 can be found on the empty bluetooth module pads:
Maybe better bend the GND pin in the opposite direction and solder the female Dupont header horizontal so that the RX pin can not shortcut to GND
my next test setup (can no longer count them):
The text was updated successfully, but these errors were encountered:
RoboDurden
changed the title
Layout 2.13 - VERY much like 2.0, but wrong hall order !
Gen2.1.11 (ex2.13) - VERY much like 2.0, but wrong hall order !
Feb 18, 2024
slave board:
Maybe better bend the GND pin in the opposite direction and solder the female Dupont header horizontal so that the RX pin can not shortcut to GND
my next test setup (can no longer count them):
![2_13 test setup robo](https://github.com/RoboDurden/Hoverboard-Firmware-Hack-Gen2.x/blob/main/Schematics_2.13/test_setup_2.13_robo.jpg?raw=true)
The text was updated successfully, but these errors were encountered: