V2.00
- Complete re-write of the low layer system to use the STM32 HAL for easier development
- This allowed easier setup for the new ADC auto measuring system
- Better tip PWM control
- Moved to FreeRTOS for scheduling
- Complete re-write from blank
- Added detailed screen views
- Added smaller font for said screen views
V1.17
- Added blinking cooldown display
- Allowed smaller sleep timeout values
- New font!
- Automatic startup option
V1.16
- Added automatic rotation support
- Added power display graph
V1.15
- Added support for a custom bootup logo to be programmed via the DFU bootloader.
V1.14
- Changed input voltage cutoff to be based on cell count rather than voltage.
V1.13
- Swapped buttons for menu to prevent accidentally changing first menu item
- Added auto key repeat.
V1.12
- Increases sensitivity options to be 1*9 with 0 off state
- Fixes issue where going from COOL *> soldering can leave screen off.
V1.11
- Boost mode
- Change sensitivity options to be 1*8
V1.10
- Adds help text to settings
- Improves settings for the display update rate
V1.09
- Adds display modes, for slowing down or simplifying the display
V1.08
- Fix settings menu not showing flip display
V1.07
- Adds shutdown time to automatically shutdown the iron after inactivity
V1.06
- Changes H and C when the iron is heating to the minidso chevron like images
V1.05
- Adds ability to calibrate the input voltage measurement
V1.04
- Increased accuracy of the temperature control
- Improved PID response slightly
- Allows temperature offset calibration
- Nicer idle screen
V1.03
- Improved Button handling
- Ability to set motion sensitivity
- DC voltmeter page shows input voltage
V1.02
- Adds hold both buttons on IDLE to access the therometer mode.
- Changes the exit soldering mode to be holding both buttons (Like original firmware).