Skip to content

Latest commit

 

History

History
62 lines (39 loc) · 1.75 KB

check-health.md

File metadata and controls

62 lines (39 loc) · 1.75 KB

Notify about health state

◀ Go back to main README

🛈 This script can not be used on its own but requires the base installation. See main README for details.

Description

This script is run from scheduler periodically, sending notification on health related events:

  • voltage jumps up or down more than configured threshold
  • power supply failed or recovered
  • temperature is above or below threshold

Note that bad initial state will not trigger an event.

Only sensors available in hardware can be checked. See what your hardware supports:

/ system health print;

Sample notifications

Voltage

check-health notification voltage

Temperature

check-health notification
check-health notification

PSU state

check-health notification
check-health notification

Requirements and installation

Just install the script and create a scheduler:

$ScriptInstallUpdate check-health;
/ system scheduler add interval=1m name=check-health on-event="/ system script run check-health;" start-time=startup;

Configuration

The configuration goes to global-config-overlay, these are the parameters:

  • CheckHealthTemperature: an array specifying temperature thresholds for sensors
  • CheckHealthVoltagePercent: percentage value to trigger voltage jumps

Also notification settings are required for e-mail, matrix and/or telegram.


◀ Go back to main README
▲ Go back to top