-
Notifications
You must be signed in to change notification settings - Fork 11
/
config.h
82 lines (63 loc) · 2.23 KB
/
config.h
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
/*****************************************************************************
* *
* DFU/SD/SDHC Bootloader for LPC17xx *
* *
*****************************************************************************/
#pragma once
#include "macros.h"
// Baudrate for debug messages
#ifndef APPBAUD
#define APPBAUD 115200
#endif
// if 1, serial messages will be printed out
#ifndef DEBUG_MESSAGES
#define DEBUG_MESSAGES 1
#endif
// if 1, serial debug messages for the USB part will be printed as well, needs DEBUG_MESSAGES
#ifndef DEBUG_MESSAGES_DFU
#define DEBUG_MESSAGES_DFU 0
#endif
// if defined, the original led code is includes (useless for the BTT SKR boards)
#ifndef LEDS
#define LEDS 0
#endif
// if 1, sdcard on display board will be checked as well
#ifndef SD_DISPLAYBOARD
#define SD_DISPLAYBOARD 1
#endif
// this was from the original code, not needed on SKR 1.3/1.4 as there are pulldown resistors installed
//#define HEATER
// if 1, USB client code will be included
#ifndef DFU
#define DFU 1
#endif
// if set, debug outputs will be prefixed by "echo: " instead of "Boot: "
#ifndef OUTPUT_ECHO
#define OUTPUT_ECHO 0
#endif
// BTN_ENC from the display board (BTT TFT35 or RepRap Full Graphic Smart
// Controller) is on pin 2 of EXP1 -> 0.28 (SKR 1.3 and 1.4), pressing the
// button while resetting forces DFU mode if no valid sd card containing
// firmware.bin was found
#ifndef DFU_PIN
#define DFU_BTN P0_28
#endif
// beeper on RepRap Full Graphic Smart Controller will beep on start due
// to pullup or some other source, let's try to configure as input with
// pulldown to avoid beeps during start (if defined)
// EXP1 pin 1 -> 1.30
#ifndef BEEPER_PIN
#define BEEPER_PIN P1_30
#endif
// SPI speed for SD card, defaults to 3 MHz (4 MHz does not work on 1.4 TURBO with BTT TFT-35)
#ifndef SPI_SPEED
#define SPI_SPEED 2000000
#endif
//----------------------------------------------------------------------------
#if ENABLED(OUTPUT_ECHO)
#define PFX "echo: "
#define EPFX "error: "
#else
#define PFX "Boot: "
#define EPFX "Boot-error: "
#endif