Can't connect to WiFi because of Firmware

[deme45]

Allevi 2 Firmware problem

Hopefully this is the right place to talk about this. I tried connecting my Allevi 2 printer through WiFi, but had many problems when doing printing because of the instability of the WiFi signal at the building. I tried the tutorials and used the USB Drive provided and it helped a little but still had some problems related to the building WiFi. Same happened with Ethernet somehow.

I was asked to look for the firmware used by the Azteeg X3Pro v1.11 motherboard, upload it and try to find where to disable WiFi, so that we could use it without that problem, only sending the commands through cable. However, now that I re-uploaded the Firmware, the machine won't listen to any commands.

I'm using Repetier-Host to send G-Code to the Allevi with the manual provided by Allevi, but it doesn't respond to anything I send. Also tried to modify Marlin extruders' pins, but still doesn't respond.

If it helps in anyway, the Baud Rate that I'm using is 250,000, and the firmware that I uploaded was from RAMPS, using the pins_AZTEEG_X3_PRO.h