-
Notifications
You must be signed in to change notification settings - Fork 0
/
Kconfig
63 lines (48 loc) · 2.07 KB
/
Kconfig
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
config ACX
tristate "TI acx100/acx111 802.11b/g wireless chipsets"
depends on NET_RADIO && EXPERIMENTAL && (USB || PCI)
select FW_LOADER
---help---
A driver for 802.11b/g wireless cards based on
Texas Instruments acx100 and acx111 chipsets.
This driver supports Host AP mode that allows
your computer to act as an IEEE 802.11 access point.
This driver is new and experimental.
Texas Instruments did not take part in development of this driver
in any way, shape or form.
The driver can be compiled as a module and will be named "acx".
config ACX_PCI
bool "TI acx100/acx111 802.11b/g PCI"
depends on ACX && PCI
---help---
Include PCI and CardBus support in acx.
acx chipsets need their firmware loaded at startup.
You will need to provide a firmware image via hotplug.
Firmware may be in a form of single image 40-100kb in size
(a 'combined' firmware) or two images - main image
(again 40-100kb) and radio image (~10kb or less).
Firmware images are requested from hotplug using following names:
tiacx100 - main firmware image for acx100 chipset
tiacx100rNN - radio acx100 firmware for radio type NN
tiacx100cNN - combined acx100 firmware for radio type NN
tiacx111 - main acx111 firmware
tiacx111rNN - radio acx111 firmware for radio type NN
tiacx111cNN - combined acx111 firmware for radio type NN
Driver will attempt to load combined image first.
If no such image is found, it will try to load main image
and radio image instead.
Firmware files are not covered by GPL and are not distributed
with this driver for legal reasons.
config ACX_USB
bool "TI acx100/acx111 802.11b/g USB"
depends on ACX && (USB=y || USB=ACX)
---help---
Include USB support in acx.
There is only one currently known device in this category,
D-Link DWL-120+, but newer devices seem to be on the horizon.
acx chipsets need their firmware loaded at startup.
You will need to provide a firmware image via hotplug.
Firmware for USB device is requested from hotplug
by the 'tiacx100usb' name.
Firmware files are not covered by GPL and are not distributed
with this driver for legal reasons.