diff --git a/components/light/shelly_dimmer.rst b/components/light/shelly_dimmer.rst
index 7b5899067a..09c0a5cbcf 100644
--- a/components/light/shelly_dimmer.rst
+++ b/components/light/shelly_dimmer.rst
@@ -93,6 +93,68 @@ Configuration variables:
 
 - All other options from :ref:`Light <config-light>`.
 
+Automatic calibration
+---------------------
+
+Many dimmable light bulbs have non-linear characteristic. This means that changing brightness from 100% to 80% can
+have no visible change, but a change from 50% to 40% can decrease visible output by a third. You can partially overcome
+this by hand-picking ``min_brightness`` and ``max_brightness`` values, but this only helps in aligning 0% and 100%
+levels to the actual output. The curve between these values is still likely to be non-linear. Original Shelly firmware
+supports automatic calibration that helps make this curve more linear resulting in smoother control across the whole
+spectrum.
+
+An attempt was made to replicate this process in Shelly Dimmer component for ESPHome. In order to be able to calibrate
+your dimmer, you need to take several steps:
+
+1. Optionally remove ``min_brightness`` and ``max_brightness`` from your Shelly ``light`` section. Calibration process
+   will respect these values if they are set, but they are not needed unless you intentionally wish to limit your
+   brightness levels.
+2. Add ``output_id`` to your ``light`` configuration. This id will be used to access calibration functions from lambdas.
+3. Add a template button that calls ``start_calibration`` function to begin calibration process.
+
+.. code-block:: yaml
+
+    light:
+      - platform: shelly_dimmer
+        id: dimmer
+        output_id: shelly
+
+
+    button:
+      - platform: template
+        id: calibrate_button
+        name: "Calibrate"
+        entity_category: config
+        on_press:
+          then:
+            - lambda: |-
+                id(shelly)->start_calibration();
+
+4. You can also create another button to clear calibration data and revert your dimmer to its original behavior:
+
+.. code-block:: yaml
+
+    button:
+      - platform: template
+        id: clear_calibration_button
+        name: "Clear calibration"
+        entity_category: config
+        on_press:
+          then:
+            - lambda: |-
+                id(shelly)->clear_calibration();
+
+5. Set logger level to ``DEBUG`` if you want to observe the calibration process in detail.
+
+Upload firmware as usual and press the "Calibrate" button that appears in Home Assistant. The following will happen:
+
+1. Light will be turned on and set to full brightness.
+2. Nothing will happen for a warmup period of 20 seconds.
+3. Every 3 seconds brightness will decrease by 5%. Power drawn by the light bulb will be measured each second, producing
+   a single measurement averaged over 3 steps. Calibration process takes 60 seconds in total.
+4. Calibration results will be saved to device memory and brightness level will be brought back to 100%.
+5. Calibration is complete! You can change brightness value and observe whether it became more linear.
+
 
 See Also
 --------