This Suction Cup Mount Kit adds suction cups to the back of your Jetson Nano, so you can stick it in hard-to-reach or moving surfaces. The suction cups work best on clean, smooth surfaces, such as glass or acrylic.
Suction Cup Mount (Overall) | Suction Cup Mount (Detail) |
---|---|
Here's a few project ideas to get started:
- Mount inside your car, and use the Nano to create a DIY head's up display
- Mount to a window, and use the Nano as a motion detector
- Mount to a dry-erase board, and use the Nano for real-time sketch recognition
Nano Clip | Board Backer | Suction Cup Clips |
---|---|---|
jetson_nano_clip.stl | nano_board_backer.stl | jetson_nano_clips_suction-cup.stl |
Item | Qty | Reference |
---|---|---|
Board Back | 1 | jetson_nano_board.stl |
Nano Clip | 2 | jetson_nano_clip.stl |
Suction Cup Clip | 4 | jetson_nano_clips_suction-cup.stl |
30mm Suction Cups | 4 | Assorted Suction Cups |
- Print the jetson_nano_board.stl, two jetson_nano_clip.stl, and four [jetson_nano_clips_tripod.stl](jetson_nano_clips_suction-cup.stl at 20% infill.
- Slide the two Jetson Nano Clips into the front of the printed board (this should be a tight fiction fit).
- Note: The front of the board has centered slots and a rougher finish.
- Snap your Jetson Nano into the Clips — you should hear a nice click sound.
- Slide a 30mm suction cup into each of the Suction Cup Clips (this should be a tight fiction fit).
- Slide each of the Suction Cup Clips into the back of the printed board (this should be a tight fiction fit).
- Note: The back of the board has off-centered slots and a smoother finish.
- Thoroughly clean the surface you'll be suctioning to, and then give the assembly a good press down onto the surface.
- These suction cups work best on completely smooth surfaces, such as glass.
- Stick it and go!
Each of these parts were printed on a Prusa i3 MK3S printer using the MK3S_MK3_0.2_Fast profile (0.2mm layer height) with PLA.
- The Nano Clip was derived from this 8020 Rail ATMega2560 Clip by the_digital_dentist.