Note
Total time spent printing is 24 hours per winding unit
Total filament used is approximately 300g per winder
- These are general priting recommendations.
- Remember that you know your printer better than I.
- The following models will require support:
STRUCT_mid_platewatch_mount
- The model is designed to be printed with PLA, therefore tolerances are spec'd for that
- Tolerances are between
0.1 - 0.2mm
- Tolerances are between
- Print with 25% infill
- This will the increase overall rigidity of the model, especially when dealing with the motor's torque.
- This will also give you a "premium feeling" product.
- If your printer has a tendency elephant foot, you'll need to file down some of the pieces.
- For example, the
mounting_dowel's outter lip will need to be filed down so themounting_dowel_sleevecan easily slip over it.
- For example, the
| Model Name | Quantity To Print | Printing Time Per Unit | Printing Orientation |
|---|---|---|---|
clutchless_drive_pulley_v2 |
1 | 2 hours |  |
motor_drive_pulley_v3 |
1 | 0.5 hours |  |
mounting_dowel_v3 |
4 | 0.75 hours p/unit |  |
mounting_dowel_sleeve_v3 |
4 | 0.25 hours p/unit |  |
STRUCT_back_plate_v2 |
1 | 3 hours |  |
STRUCT_mid_plate_v2 |
1 | 3 hours |  |
STRUCT_front_plate_v2 |
1 | 2 hours |  |
tensioner_pulley_v1 |
1 | 0.25 hours |  |
tensioner_pulley_mount_v2 |
1 | 0.25 hours |  |
high_position_tensioner_pulley_mount_v1 |
1 | 0.25 hours |  |
watch_jig_collar_v4 |
1 | 0.25 hours |  |
watch_jig_driveshaft_v3 |
1 | 1 hour |  |
watch_jig_v4 |
1 | 6 hours |  |
watch_mount_v7 |
1 | 2 hours |  |
multi_clip |
4 | 0.25 hours p/unit |  |
spring_holder_v3 |
1 | 1 hours |  |
top_hat_v2 |
1 | 0.25 hours |  |