Replies: 2 comments
-
I have GD32F303 on a 4.2.2 board. I have klipper connected to moonraker/mainsail - it's taking commands and seems to be working although I am not finished with all of the config yet; also 8 am doing this thru Linux on a desktop not via a raspberry ..for me, I seem to have it working with the following: in make menuconfig select that you to enable extra low-level options then type Q and Y to close and save. reopen make menuconfig again and select stm32f103, select disable swd, and select 28KiB bootloader. change the communication to USB on (PA11/PA12); type Q and Y again to save and exit, then run 'make' in terminal. flash the firmware it generates to your board. connect printer via usb and run 'ls /dev/serial/by-id/*' to get the address that you will use in [mcu] section. that got my steppers responding and now i'm just filling in the rest of the config and hoping for the best - so far so good. good luck |
Beta Was this translation helpful? Give feedback.
-
Please excuse me for any noob mistakes; it's my first post and I never expected to have to get into this at all. |
Beta Was this translation helpful? Give feedback.
-
Hi creality made some changes using another microcontroler for ender 3 v2 .anymore they are using GD32F303 in order of stm32f103, but the result is that we cant install Klipper to our machines. Even some options from Marlin firmwares some times we cant use them correct. Does anybody know what we should do to use Klipper to our machines?
Beta Was this translation helpful? Give feedback.
All reactions