If you are not running Firmware 4.4.3, then DO NOT install Mariner from this fork. It is unlikely to work.
mnbf9rca: merged changes from both https://github.com/Desterly/mariner (encryption) and https://github.com/BlueFinBima/mariner (main work)
Requires Python 3.x. Install as follows:
- libatlas-base-dev (for libcblas.so.3) - install with sudo apt-get install -y libatlas-base-dev
(from https://l9o.dev/posts/controlling-an-elegoo-mars-pro-remotely/)
- modify /boot/config.txt to add dtoverlay=dwc2 to the end of the file
- enable the dwc2 module by adding modules-load=dwc2 to /boot/cmdline.txt just after rootawait
- create a file to store uploaded files. This creates a 2GB file and creates a file system on it - it can take quite some time to create the file. We then create a mountpoint.`:
`bash
sudo dd bs=1M if=/dev/zero of=/piusb.bin count=2048
sudo mkdosfs /piusb.bin -F 32 -I
sudo mkdir -p /mnt/usb_share
`
- add the following to /etc/fstab:
`
/piusb.bin /mnt/usb_share vfat users,gid=mariner,umask=002 0 2
`
- its important to check that the share mounts or it'll block boot: sudo mount -a
- update /etc/rc.local to load the g_mass_storage module on boot by adding the line modprobe g_mass_storage file=/piusb.bin stall=0 ro=1 before exit 0. This command does that, or you can do it manually:
`bash
sudo sed -i 's/exit 0/modprobe g_mass_storage file=\/piusb.bin stall=0 removable=1 ro=0;\nexit 0/' /etc/rc.local
`
Check-out releases on this project for a deb file which can be installed if you're running 4.4.3.
Web interface for controlling MSLA 3D Printers based on ChiTu controllers remotely. This fork is to allow Mariner to work with Firmware 4.4.3 which had to be installed in order to allow ChitBox 1.9 sliced files to be printed. It was found that Mariner did not work with this Firmware level because a number of the commands stopped working.
The issue with 4.4.3 was raised as luizribeiro#453
- Web interface with support for both desktop and mobile.
- Upload files to be printed through the web UI over WiFi!
- Remotely check print status: progress, current layer, time left.
- Remotely control the printer: start prints, pause/resume and stop.
- Browse files available for printing.
- Inspect
.ctbfiles: image preview, print time and slicing settings.
For more details on the feature set, refer to our Documentation.
Mariner supports a wide range of MSLA printers, including printers from the following manufacturers:
- Anycubic
- Creality
- EPAX
- Elegoo
- Peopoly
- Phrozen
- Voxelab
Please refer to the list of Supported Printers on our documentation for a full list of printer models that have been tested. If you have access to other printers and want to contribute, please open an issue. We're happy to support more printers!
The documentation is available from Read the Docs. It contains a lot of information from how to setup the hardware, install the software, troubleshoot issues, and how to contribute to development.
This blog post explains the setup end to end with pictures of the modifications done to an Elegoo Mars Pro.