You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
I want to use unipager with an NW Digital Radio UDRC (v1) board attached to a Raspberry Pi 2B. The physical pin is 32 which equals to wiring PI GPIO26. To manually toogle the gpio pin via "gpio write 26 0" or "gpio write 26 1" in the console works fine, confirming the number is correct.
However, when I check with "gpio readall" I found strange behaviour in Unipager using the GPIO pins. Examples:
I want to use unipager with an NW Digital Radio UDRC (v1) board attached to a Raspberry Pi 2B. The physical pin is 32 which equals to wiring PI GPIO26. To manually toogle the gpio pin via "gpio write 26 0" or "gpio write 26 1" in the console works fine, confirming the number is correct.
However, when I check with "gpio readall" I found strange behaviour in Unipager using the GPIO pins. Examples:
Issue: The GPIO26 (BCM 12, Pin 32) can't be used with Unipager
The text was updated successfully, but these errors were encountered: