Skip to content

Latest commit

 

History

History
77 lines (48 loc) · 2.01 KB

pre-commit-usage.rst

File metadata and controls

77 lines (48 loc) · 2.01 KB

Using Pre-Commit

pre-commit is a program used to configure and run Git hooks. These hooks can be triggered in different Git stages, though typically we use them in only commit and push stages.

See the pre-commit config contents document for descriptions of the current hooks.

Each of the hooks will run in its own small virtual environment.

Setup

The program must be installed and the hooks must be configured. The program should be installed in your usual virtual environment, for example, "venv" (this could also be a conda environment).

After activating your environment, run the following commands:

(venv) $ pip install pre-commit
(venv) $ pre-commit install
(venv) $ pre-commit install-hooks
(venv) $ pre-commit autoupdate

Automatic Usage

In normal usage, pre-commit will trigger with every git commit and every git push. The hooks that trigger in each stage can be configured by editing the .pre-commit-config.yaml file. The files that have changed will be passed to the various hooks before the git operation completes. If one of the hooks exits with a non-zero exit-code, then the commit (or push) will fail.

Manual Usage

To manually trigger pre-commit to run all hooks on CHANGED files:

(venv) $ pre-commit run

To manually trigger pre-commit to run all hooks on ALL files, regardless if they are changed or not:

(venv) $ pre-commit run --all-files

To manually trigger pre-commit to run a single hook on changed files:

(venv) $ pre-commit run <hook-id>

To manually trigger pre-commit to run a single hook on all files:

(venv) $ pre-commit run <hook-id> --all-files

For example, to run pylint on all files:

(venv) $ pre-commit run pylint --all-files