Resulting image try to update itself at first boot and tailscale is enabled

[BenPi-Ross]

Hello scpcom!

First of all thank you very much for your work!

I'm not sure if this is really an issue, but that's the only place I found to contact you.

So I followed the instructions in this post (and the information in the readme of the repo) about building LicheeSG-Nano-Build.

The resulting image, once flashed on the SD card and booted on my NanoKVM-PCIe, still tries to update itself after booting (it shows it's trying to update on the screen in loop since it currently don't have Internet access in the VLAN it's connected in). I also observed that tailscale is enabled.

You said in the post I mentioned above that "NanoKVM itself does not need any internet connection to work, no additional downloads required." So I'm wondering why it tries to update itself at boot. Is it normal?

You also said in another post that tailscale is supposed to be disabled by default and that you can enable it with the parameter "--tailscale" to the "./build-nanokvm.sh" command. I didn't use that parameter and tailscale is still running once booted.

So I'm wondering if I done something wrong when building it?

Thanks!

[BenPi-Ross]

Hello again!

I think it's a problem specific for the NanoKVM-PCIe.

I flashed the same image on my NanoKVM, and it works as expected. No auto-update and tailscale is not enabled.

[scpcom]

If you build the image without the tailscale flag it can not be running because the binaries are not included. Maybe the SD card did contain a different image?
But i can not help much because I do not have NanoKVM-PCIe. My work is only tested on NanoKVM Light and Full.