-
Notifications
You must be signed in to change notification settings - Fork 66
The default login is root with the password root.
Turn off the camera's power. Press and hold the reset button, then turn the power back on. Keep holding the button for 5 seconds during boot. This should reset the camera to its default settings with root as a password. Your camera needs to have the gpio_button
pin set!
Change it in bootloader environment with fw_setenv
command. Use ethaddr
parameter for ethernet interface, wlanmac
for wireless interface.
fw_setenv ethaddr 12:34:56:78:AB:CD
fw_setenv wlanmac 12:34:56:78:AB:EF
We recommend to use tinyCam Monitor Pro.
If the camera in question has an Ingenic SoC, there is a good chance that Thingino can run on it. You can try to convert it using one of the prebuilt module firmware files or build a new one yourself. Donate such a camera to the project to speed up the process!
See our complete table of Supported Hardware.
Thingino was influenced by the ideas of the OpenIPC project, and core developers even collaborated with OpenIPC for a while, but then the differences became too deep and thingino was born.
While there are some similarities, there are also significant differences between these two projects.
Thingino does not collect any data metrics or telemetry, ensuring your data remains solely on your device and entirely under your control. Being fully open source, Thingino allows you to audit the code and verify its operations, providing full transparency and peace of mind. We Don't Want Your Data!