SCREWS_TILT_CALCULATE issue

[klich3]

I am not sure if it is a bug but when using the eddy-ng the SCREWS_TILT_CALCULATE command makes a kind of tap on the fourth point and then goes from 1 to 4 but without lowering the head, as if doing a read, which is normally not correct. Am I doing something wrong?

[vvuk]

Hmm. Not sure what you mean. But it should move at the horizontal_move_z height and do a scan at that height. Can you describe the behaviour?

[klich3]

I have an Ender converted to Switchwire with the CORE XZ, I level the table with M4 screws, previously the reading was done as if it were an endstop, now what it does is moderately correct that it passes through the point and makes the reading, but the reading is not correct, in all points it returns the same value.

[klich3]

This is the three passes without adjustment of the table each time checking gives totally different values.