How to get the image controls when the image is also a link?

[LorenAmelang]

I run into this occasionally... I save a web page, and an included image is also a URL link. If I click the image in Trilium without being in edit mode, the web page opens.

In edit mode, if I want to, say, reduce the size of the image, I seem to almost always get the link control popup:

If I poke around long enough, I can usually get the image controls, but I'm not sure how it happens, and it is very fragile - most any action will revert to the link controls:

Is there some clear tactic for accessing the image options?

[maphew]

There's the inverse problem also: how to get at Link properties for an image when the image properties are active?

[LorenAmelang]

Just tried this again, in 0.63.5. When I click in the image, the image properties bar flashes above the image, then disappears and the link properties bar opens under the image. If I then press the Esc key, the link properties bar is replaced by the image properties bar, now below the image. Seems useful...

@maphew No, it doesn't seem to go back to link properties if I Esc again. But maybe it would swap once if you get image properties first?

But if I move the mouse while making that initial click in the image, it draws a small floating version of the image on top of the full version, and when I release the click the whole image disappears! Thankfully Ctrl+Z will bring it back.

[maphew]

Thanks for the tip about Esc, I can use that.

The only way I've discovered so far to have an image with a link is to create that in something else and then paste the image+link into Trilium. After that I can get to the link properties popup as described above.