Shelly Wave restore state after a power failure not working

[pm-melo]

Checklist

• I have read and followed the above instructions

• I have checked the troubleshooting section and my problem is not described there.

• I have read the changelog and my problem was not mentioned there or the fix did not work.

Describe the issue

What is happening?
Hi everyone! I'm using a Shelly Wave 1PM with a light connected to it. The device appears to work correctly apart from parameter 17 of the device. According to the manufacturer specification (link) - this parameter should allow for a state restore after power is cut to the device. I'm not seeing this work. To me, after a power loss, the device always becomes off.

What did you expect to happen instead?
The device should restore the switch state after a power loss.

Steps to reproduce the behavior:

1. Go to 'Control Pannel'
2. Click on the device to expand
3. Scroll down to 'Configuration V4', set the parameter '[6-112-0-17] O1: State After Power Failure' to 0 (should make the device restore the state according to the manufacturer)
4. Turn the device switch on. Disconnect the device from power. Wait a few seconds. Connect power again and validate that the devices stays off.

Software versions

zwave-js-ui: 9.28.0.e336517
zwave-js: 14.3.7
home id: 3817940233
home hex: 0xe3912509

Z-Wave Controller (Stick/Dongle/...)

I'm using a Zooz 800 USB stick

Device information

No response

Checklist

• I made sure to provide a driver log on level debug.

• The log includes a re-interview of the problematic device (if applicable).

• The log includes the problematic interaction with the device (if applicable).

• I provided the node ID of the problematic device (if applicable).

Upload Logfile

zwave_js.log