This is my implementation of Stanford CS144's lab. All 7 labs are been done and the completed source code is located at libsponge/
. My blog on this course is available at CSDN.
==========Contents below are from the original README.==========
For build prereqs, see the CS144 VM setup instructions.
To set up your build directory:
$ mkdir -p <path/to/sponge>/build
$ cd <path/to/sponge>/build
$ cmake ..
Note: all further commands listed below should be run from the build
dir.
To build:
$ make
You can use the -j
switch to build in parallel, e.g.,
$ make -j$(nproc)
To test (after building; make sure you've got the build prereqs installed!)
$ make check_labN *(replacing N with a checkpoint number)*
The first time you run make check_lab...
, it will run sudo
to configure two
TUN devices for use during
testing.
You can specify a different compiler when you run cmake:
$ CC=clang CXX=clang++ cmake ..
You can also specify CLANG_TIDY=
or CLANG_FORMAT=
(see "other useful targets", below).
Sponge's build system supports several different build targets. By default, cmake chooses the Release
target, which enables the usual optimizations. The Debug
target enables debugging and reduces the
level of optimization. To choose the Debug
target:
$ cmake .. -DCMAKE_BUILD_TYPE=Debug
The following targets are supported:
Release
- optimizationsDebug
- debug symbols and-Og
RelASan
- release build with ASan and UBSanRelTSan
- release build with ThreadSanDebugASan
- debug build with ASan and UBSanDebugTSan
- debug build with ThreadSan
Of course, you can combine all of the above, e.g.,
$ CLANG_TIDY=clang-tidy-6.0 CXX=clang++-6.0 .. -DCMAKE_BUILD_TYPE=Debug
Note: if you want to change CC
, CXX
, CLANG_TIDY
, or CLANG_FORMAT
, you need to remove
build/CMakeCache.txt
and re-run cmake. (This isn't necessary for CMAKE_BUILD_TYPE
.)
To generate documentation (you'll need doxygen
; output will be in build/doc/
):
$ make doc
To format (you'll need clang-format
):
$ make format
To see all available targets,
$ make help