v4.10

Improvement:

• Script:

  • Add filter to ignore snapper's snapshot "type or description" during run "grub-mkconfig" (#158) ...
  • Add possibility to boot without init(rd,ramfs) (#164) :
    • For a snapshot to be valid, it must contain a boot folder and a kernel from the official list
      (or have been added to the custom kernel list)
    • if a snapshot doesn't contain an init(rd,ramfs), it will be detected as valid.
    • Suppress script stop when an init is not found
  • Adds trap command on EXIT signal:
    • Now umount command will launch on EXIT signal.
    • Adds a function called by the trap on EXIT signal to unmount and delete the temporary folder.
      (That should be the end of multiple tmp.xxxxxxxxxx in /tmp)
      • If the command fails, retry every 2 seconds. After 10 attempts, it will stop and display a warning.
      • If the command is successful, "Succes" will be displayed.
    • Adds "grub-btrfs" as a prefix to the temporarie mount folder.
      (before = tmp.xxxxxxxxx , now = grub-btrfs.xxxxxxxxxx)
  • Rework the creation of the "grub-btrfs.cfg" file:
    • Before, the "grub-btrfs.cfg" file was deleted and then the new configuration was written.
      No backup was made.
    • Now, the new configuration will be written in a temporary file "grub-btrfs.new" and then analysed with the "grub_script_check" command before being finally written in the "grub-btrfs.cfg" file.
      If an error is detected, the "grub-btrfs.new" file will coexist with the old "grub-btrfs.cfg" file, if it exists.

• Config file:

  • Add Two new variables:

    • "GRUB_BTRFS_IGNORE_SNAPPER_TYPE"
      Ignore specific type of snapper's snapshot during run "grub-mkconfig".
      Type = single, pre or post.

    • "GRUB_BTRFS_IGNORE_SNAPPER_DESCRIPTION"
      Ignore specific description of snapper's snapshot during run "grub-mkconfig".
      See Config file

Miscellaneous:

• Script:

  • Removes double negation in file test operators
  • Remove redundant check
  • Deactivate the script as soon as possible …
    With these changes, the script will be disabled as soon as possible, if :
    • "GRUB_BTRFS_DISABLE" If this variable is set to "true"
    • "btrfs-progs isn't installed" This package is required to retrieve information from the btrfs filesystem.
    • "grub-mkconfig_lib couldn't be found" This library is required because the script depends on it.
    • "Root filesystem isn't btrfs" grub-btrfs currently checks only the btrfs snapshots present on the root partition.
  • Corrects printf format string
  • Update header installation section:
    • Remove instructions
      (Refer to the project website, installation section)
  • Deletes unused code:
    • Limit generation of menuentries if exceeds 250 has never been used.
      Uses "GRUB_BTRFS_LIMIT" (default 50) instead.
  • Write-protect user data
    • The script does not need write access to the data.
      Adds "ro" flags to provide protection against accidental writing.

• Readme:

  • Update "Installation section":
    • Adds required dependencies
    • Indicates that the command "update-grub", is an alias to "grub-mkconfig" on Debian-like distributions.