Setup Unicable and JESS

It is important to remember to press 'Enter' key after changing values to save your changes

• In the 'Frontend 0' Tab (see below) there is an section 'DiSEqC Configuration' there you have:
  • 'Repeat DiSEqC'     -- specifies how many times the DiSEqC command should be repeated
  • 'DiSEqC'            -- specifies 'DiSEqC Switch' / 'Unicable (EN50494) / 'Jess/Unicable 2 (EN50607)'
  • 'Channel Freq (MHz)' -- specifies the 'User Band' or SCR frequency
  • 'Channel Slot (0-32)'  -- specifies the 'User Band' number starting with 0 as first SCR, so always subtract 1
  • 'Delay before write'   -- specifies the time to wait after 18V is set and before sending DiSEqC command
  • 'Delay after write'     -- specifies the time to wait after sending DiSEqC command and before 13V is set back
  • 'PIN (256 disabled)'  -- specifies the PIN set for this Frontend
  • When having difficulties getting a signal lock, try increasing
    'Delay before write' and 'Delay after write' to 100 or more
• Setup the correct LOF for LNB

---