v1.52.1

In this release, S4ACS verifies the content of the S4ICS status, before starting the acquisition of a new sequence in the polarimetric mode. In this verification, S4ACS will wait until the WPPOS status to change from the BUSY state to the READY state. If, after a series of verifications, this change does not occur, the acquisition will be canceled.

v1.51.3

This release fix the problem related to the values of the keyword WPPOS. In some polarimetric measurements, these values were appearing as zero, rather than the expected waveplate position. To fix this, the update delay of the S4ICS messages was reduced to 50 ms. In addition, in this release, the used disk space is published in the S4CCS status message.

Release v1.51.2

This release fix the problem related to the communication using the Communication Manager project.
This problem was related to the time of 100 ms set for the manager used in S4CCS to execute one iteration of its internal loop, together with the timeout of 200 ms set for the manager used in S4GUI. There were some situations where S4CCS needed two iterations (200 ms) to answer a request. This answer, in turn, was interpreted as a timout event by S4GUI.