Flashing update loose settings?

[JonSnow88]

Will flashing updates reset the printer?

What about moving from 3x3 to 5x5 bin files. Assume that means i need to run the mesh bed level?

[t3chguy]

Whenever you update Marlin in general, not just this fork, it is recommended you reset to defaults as values in EEPROM may have changed meaning.

[JonSnow88]

I was afraid this would be the answer, I've been struggling with allot of first layer problems. Finally have my settings dialed in but wanted to flash a newer update.

However the first layer problems have been mostly mechanical rather than software, requiring me to redo allot of the factory assessbly.

[darco415]

you can always reflash then run a test print...adjust accordingly

[Woodcat64]

If you just worry about motion/step ratios and offsets. Write those down. Load new FW and later put your values back in.

[JonSnow88]

Yep but the one time i didn't write it down after adjusting z axis