Z-Offset Issues

[shawnb2]

Please excuse my major noobness as I'm not very savvy with GitHub or Reddit and how it all works. I'm running this firmware on my V2 and overall it's awesome but I do have an issue and want to see if you could help. I'm running the version with BLTouch and fast probing but when I went to set z-offset it wouldn't adjust in live time. I would have to get the nozzle close at first and then dial it in a couple hundredths at a time but it wouldn't adjust after I clicked the wheel. Would have to back out of the screen and then it would adjust and would go back to recheck for proper height. Rinse and repeat. I unfortunately didn't fully figure this out until I sacrificed my new PEI Sheet. I have it set now and it's works great but wanted to see if this is a known issue that could be fixed or if I'm the lucky one. Either way, if there's a way to fix it I would greatly appreciate it. Thanks.

[Jyers]

Just a sanity check here... Did you enable "Live Adjust"?

[Jyers]

I believe there is someone who should be making a video guide on this firmware, so hopefully soon people won't have to go in blind :)

[npike]

When Live Adjust is enabled in the z-offset menu, should the nozzle be moving when I change the offset? Mine seems to stay parked unless I re-home the z-offset after each change.

[Jyers]

Yes, it should be moving. If you continue to face this issue, feel free to create a bug report in the issue section of github.

[Schnabulation]

Is it needed to habe BABYSTEP_ALWAYS_AVAILABLE defined for the live-adjust to be working?

[Jyers]

As far as I know BABYSTEP_ALWAYS_AVAILABLE should not have any impact on the z offset menu. I have always used it without this enabled and it has never been an issue.