kernel module and device tree overlay to add support for the EMC2301 fan controller on the Raspberry Pi Compute Module 4 IO Board.
Works with 5.10.y 64-bit kernels only.
Uses Traverse Technologies' EMC2301 hwmon driver for their ten64 board, which you should definitely check out because it's awesome.
- Install dkms if you haven't already:
sudo apt install dkms
- Download the latest source .tar.gz from the releases page
- Untar it to
/usr/src/cm4io-fan-<version>and run the dkms install:
tar -xzvf 0.1.1.tar.gz -C /usr/src/
sudo dkms install cm4io-fan/0.1.1
- Add this line to your /boot/config.txt (adjust the rpm values for your specific fan, defaults are 3500 / 5500) and reboot. See below for more config options.
dtoverlay=cm4io-fan,minrpm=1000,maxrpm=5000
- Install dkms if you haven't already:
sudo apt install dkms
- Clone the repo
mkdir -p ~/src
cd ~/src
git clone https://github.com/neg2led/cm4io-fan.git
cd cm4io-fan
- Run install.sh, feel free to inspect it yourself first. It will archive the current HEAD to /usr/src with an appropriate version, and run DKMS.
The device tree overlay has a few options, here's the equivalent of a /boot/overlays/README info section:
Name: cm4io-fan
Info: Raspberry Pi Compute Module 4 IO Board fan controller
Load: dtoverlay=cm4io-fan,<param>[=<val>]
Params: minrpm RPM target for the fan when the SoC is below
mintemp (default 3500)
maxrpm RPM target for the fan when the SoC is above
maxtemp (default 5500)
midtemp Temperature (in millicelcius) at which the fan
begins to speed up (default 50000)
midtemp_hyst Temperature delta (in millicelcius) below mintemp
at which the fan will drop to minrpm (default 2000)
maxtemp Temperature (in millicelcius) at which the fan
will be held at maxrpm (default 70000)
maxtemp_hyst Temperature delta (in millicelcius) below maxtemp
at which the fan begins to slow down (default 2000)
- taudac/taudac-driver-dkms for helping me work out how the shit DKMS works
- Traverse Technologies for the kernel module