Added new board "MatekH743-slim"

.ci/Jenkinsfile-compile

@@ -59,6 +59,7 @@ pipeline {
                      "holybro_durandal-v1_default",
                      "holybro_kakutef7_default",
                      "holybro_pix32v5_default",
+                     "matek_h743-slim",
                      "modalai_fc-v1_default",
                      "modalai_fc-v1_rtps",
                      "modalai_fc-v2_default",

.github/workflows/compile_nuttx.yml

@@ -34,6 +34,7 @@ jobs:
           holybro_durandal-v1,
           holybro_kakutef7,
           holybro_pix32v5,
+          matek_h743-slim,
           modalai_fc-v1,
           modalai_fc-v2,
           mro_ctrl-zero-f7,

.vscode/cmake-variants.yaml

@@ -186,6 +186,11 @@ CONFIG:
       buildType: MinSizeRel
       settings:
         CONFIG: holybro_durandal-v1_default
+    matek_h743-slim_default:
+      short: matek_h743-slim
+      buildType: MinSizeRel
+      settings:
+        CONFIG: matek_h743-slim_default
     modalai_fc-v1_default:
       short: modalai_fc-v1
       buildType: MinSizeRel

boards/matek/h743-slim/bootloader.px4board

@@ -0,0 +1,3 @@
+CONFIG_BOARD_TOOLCHAIN="arm-none-eabi"
+CONFIG_BOARD_ARCHITECTURE="cortex-m7"
+CONFIG_BOARD_ROMFSROOT=""

boards/matek/h743-slim/default.px4board

@@ -0,0 +1,82 @@
+CONFIG_BOARD_TOOLCHAIN="arm-none-eabi"
+CONFIG_BOARD_ARCHITECTURE="cortex-m7"
+CONFIG_BOARD_SERIAL_GPS1="/dev/ttyS1"
+CONFIG_BOARD_SERIAL_TEL1="/dev/ttyS2"
+CONFIG_BOARD_SERIAL_TEL2="/dev/ttyS3"
+CONFIG_BOARD_SERIAL_TEL3="/dev/ttyS5"
+CONFIG_BOARD_SERIAL_TEL4="/dev/ttyS6"
+CONFIG_DRIVERS_ADC_BOARD_ADC=y
+CONFIG_COMMON_BAROMETERS=y
+CONFIG_DRIVERS_CAMERA_CAPTURE=y
+CONFIG_DRIVERS_CAMERA_TRIGGER=y
+CONFIG_COMMON_DISTANCE_SENSOR=y
+CONFIG_DRIVERS_DSHOT=y
+CONFIG_DRIVERS_GPS=y
+CONFIG_DRIVERS_IMU_INVENSENSE_MPU6000=y
+CONFIG_DRIVERS_IMU_INVENSENSE_ICM20602=y
+CONFIG_COMMON_LIGHT=y
+CONFIG_COMMON_MAGNETOMETER=y
+CONFIG_COMMON_OPTICAL_FLOW=y
+CONFIG_DRIVERS_OSD=y
+CONFIG_DRIVERS_PWM_OUT=y
+CONFIG_DRIVERS_PWM_OUT_SIM=y
+CONFIG_DRIVERS_RC_INPUT=y
+CONFIG_DRIVERS_RPM=y
+CONFIG_COMMON_TELEMETRY=y
+CONFIG_DRIVERS_TONE_ALARM=y
+CONFIG_DRIVERS_UAVCAN=y
+CONFIG_MODULES_ATTITUDE_ESTIMATOR_Q=y
+CONFIG_MODULES_BATTERY_STATUS=y
+CONFIG_MODULES_COMMANDER=y
+CONFIG_MODULES_DATAMAN=y
+CONFIG_MODULES_EKF2=y
+CONFIG_MODULES_EVENTS=y
+CONFIG_MODULES_FLIGHT_MODE_MANAGER=y
+CONFIG_MODULES_GYRO_CALIBRATION=y
+CONFIG_MODULES_GYRO_FFT=y
+CONFIG_MODULES_LAND_DETECTOR=y
+CONFIG_MODULES_LANDING_TARGET_ESTIMATOR=y
+CONFIG_MODULES_LOAD_MON=y
+CONFIG_MODULES_LOCAL_POSITION_ESTIMATOR=y
+CONFIG_MODULES_LOGGER=y
+CONFIG_MODULES_MAG_BIAS_ESTIMATOR=y
+CONFIG_MODULES_MAVLINK=y
+CONFIG_MODULES_MC_ATT_CONTROL=y
+CONFIG_MODULES_MC_AUTOTUNE_ATTITUDE_CONTROL=y
+CONFIG_MODULES_MC_HOVER_THRUST_ESTIMATOR=y
+CONFIG_MODULES_MC_POS_CONTROL=y
+CONFIG_MODULES_MC_RATE_CONTROL=y
+CONFIG_MODULES_NAVIGATOR=y
+CONFIG_MODULES_RC_UPDATE=y
+CONFIG_MODULES_SENSORS=y
+CONFIG_MODULES_TEMPERATURE_COMPENSATION=y
+CONFIG_MODULES_VMOUNT=y
+CONFIG_SYSTEMCMDS_BL_UPDATE=y
+CONFIG_SYSTEMCMDS_DMESG=y
+CONFIG_SYSTEMCMDS_DUMPFILE=y
+CONFIG_SYSTEMCMDS_ESC_CALIB=y
+CONFIG_SYSTEMCMDS_GPIO=y
+CONFIG_SYSTEMCMDS_HARDFAULT_LOG=y
+CONFIG_SYSTEMCMDS_I2CDETECT=y
+CONFIG_SYSTEMCMDS_LED_CONTROL=y
+CONFIG_SYSTEMCMDS_MFT=y
+CONFIG_SYSTEMCMDS_MIXER=y
+CONFIG_SYSTEMCMDS_MOTOR_TEST=y
+CONFIG_SYSTEMCMDS_MTD=y
+CONFIG_SYSTEMCMDS_NSHTERM=y
+CONFIG_SYSTEMCMDS_PARAM=y
+CONFIG_SYSTEMCMDS_PERF=y
+CONFIG_SYSTEMCMDS_PWM=y
+CONFIG_SYSTEMCMDS_REBOOT=y
+CONFIG_SYSTEMCMDS_SD_BENCH=y
+CONFIG_SYSTEMCMDS_SD_STRESS=y
+CONFIG_SYSTEMCMDS_SERIAL_TEST=y
+CONFIG_SYSTEMCMDS_SYSTEM_TIME=y
+CONFIG_SYSTEMCMDS_TOP=y
+CONFIG_SYSTEMCMDS_TOPIC_LISTENER=y
+CONFIG_SYSTEMCMDS_TUNE_CONTROL=y
+CONFIG_SYSTEMCMDS_UORB=y
+CONFIG_SYSTEMCMDS_USB_CONNECTED=y
+CONFIG_SYSTEMCMDS_VER=y
+CONFIG_SYSTEMCMDS_WORK_QUEUE=y
+CONFIG_EXAMPLES_FAKE_GPS=y

boards/matek/h743-slim/firmware.prototype

@@ -0,0 +1,13 @@
+{
+    "board_id": 139,
+    "magic": "PX4FWv1",
+    "description": "Firmware for the MatekH743-slim board",
+    "image": "",
+    "build_time": 0,
+    "summary": "MatekH743-slim",
+    "version": "0.1",
+    "image_size": 0,
+    "image_maxsize": 1966080,
+    "git_identity": "",
+    "board_revision": 0
+}

boards/matek/h743-slim/init/rc.board_extras

@@ -0,0 +1,16 @@
+#!/bin/sh
+#
+# board specific extras init
+#------------------------------------------------------------------------------
+
+# if ! param compare OSD_ATXXXX_CFG 0
+# then
+# 	atxxxx start -s
+# fi
+
+atxxxx start -s
+
+
+# DShot telemetry is always on UART7
+# dshot telemetry /dev/ttyS5
+

boards/matek/h743-slim/init/rc.board_sensors

@@ -0,0 +1,18 @@
+#!/bin/sh
+#
+# board specific sensors init
+#------------------------------------------------------------------------------
+
+board_adc start
+
+# Internal SPI bus ICM-20602
+icm20602 -R 12 -s start
+
+# Internal SPI bus MPU-6000
+mpu6000 -R 12 -s start
+
+# Internal baro
+dps310 -I start -a 118
+
+# External mag
+qmc5883l -X start -a 13

boards/matek/h743-slim/nuttx-config/Kconfig

@@ -0,0 +1,17 @@
+#
+# For a description of the syntax of this configuration file,
+# see misc/tools/kconfig-language.txt.
+#
+config BOARD_HAS_PROBES
+	bool "Board provides GPIO or other Hardware for signaling to timing analyze."
+	default y
+	---help---
+		This board provides GPIO FMU-CH1-5, CAP1-6 as PROBE_1-11 to provide timing signals from selected drivers.
+
+config BOARD_USE_PROBES
+	bool "Enable the use the board provided FMU-CH1-5, CAP1-6 as PROBE_1-11"
+	default n
+	depends on BOARD_HAS_PROBES
+
+	---help---
+		Select to use GPIO FMU-CH1-5, CAP1-6  to provide timing signals from selected drivers.

boards/matek/h743-slim/nuttx-config/bootloader/defconfig

@@ -0,0 +1,93 @@
+#
+# This file is autogenerated: PLEASE DO NOT EDIT IT.
+#
+# You can use "make menuconfig" to make any modifications to the installed .config file.
+# You can then do "make savedefconfig" to generate a new defconfig file that includes your
+# modifications.
+#
+# CONFIG_DEV_CONSOLE is not set
+# CONFIG_DISABLE_PSEUDOFS_OPERATIONS is not set
+# CONFIG_SPI_EXCHANGE is not set
+# CONFIG_STM32H7_SYSCFG is not set
+CONFIG_ARCH="arm"
+CONFIG_ARCH_BOARD_CUSTOM=y
+CONFIG_ARCH_BOARD_CUSTOM_DIR="../nuttx-config"
+CONFIG_ARCH_BOARD_CUSTOM_DIR_RELPATH=y
+CONFIG_ARCH_BOARD_CUSTOM_NAME="px4"
+CONFIG_ARCH_CHIP="stm32h7"
+CONFIG_ARCH_CHIP_STM32H743VI=y
+CONFIG_ARCH_CHIP_STM32H7=y
+CONFIG_ARCH_INTERRUPTSTACK=512
+CONFIG_ARMV7M_BASEPRI_WAR=y
+CONFIG_ARMV7M_ICACHE=y
+CONFIG_ARMV7M_MEMCPY=y
+CONFIG_ARMV7M_USEBASEPRI=y
+CONFIG_BOARDCTL_RESET=y
+CONFIG_BOARD_INITTHREAD_PRIORITY=254
+CONFIG_BOARD_LATE_INITIALIZE=y
+CONFIG_BOARD_LOOPSPERMSEC=22114
+CONFIG_BOARD_RESET_ON_ASSERT=2
+CONFIG_C99_BOOL8=y
+CONFIG_CDCACM=y
+CONFIG_CDCACM_PRODUCTID=0x004b
+CONFIG_CDCACM_PRODUCTSTR="Matek H743-slim"
+CONFIG_CDCACM_RXBUFSIZE=600
+CONFIG_CDCACM_TXBUFSIZE=12000
+CONFIG_CDCACM_VENDORID=0x3162
+CONFIG_CDCACM_VENDORSTR="Matek"
+CONFIG_CLOCK_MONOTONIC=y
+CONFIG_DEBUG_FULLOPT=y
+CONFIG_DEBUG_SYMBOLS=y
+CONFIG_DEFAULT_SMALL=y
+CONFIG_DISABLE_MQUEUE=y
+CONFIG_DISABLE_PTHREAD=y
+CONFIG_EXPERIMENTAL=y
+CONFIG_FDCLONE_DISABLE=y
+CONFIG_FDCLONE_STDIO=y
+CONFIG_HAVE_CXX=y
+CONFIG_HAVE_CXXINITIALIZE=y
+CONFIG_IDLETHREAD_STACKSIZE=750
+CONFIG_LIBC_FLOATINGPOINT=y
+CONFIG_LIBC_LONG_LONG=y
+CONFIG_LIBC_STRERROR=y
+CONFIG_LIB_BOARDCTL=y
+CONFIG_FS_PROCFS_MAX_TASKS=8
+CONFIG_MEMSET_64BIT=y
+CONFIG_MEMSET_OPTSPEED=y
+CONFIG_PREALLOC_TIMERS=50
+CONFIG_PTHREAD_STACK_MIN=512
+CONFIG_RAM_SIZE=245760
+CONFIG_RAM_START=0x20010000
+CONFIG_RAW_BINARY=y
+CONFIG_SDCLONE_DISABLE=y
+CONFIG_SERIAL_TERMIOS=y
+CONFIG_SIG_DEFAULT=y
+CONFIG_SIG_SIGALRM_ACTION=y
+CONFIG_SIG_SIGUSR1_ACTION=y
+CONFIG_SIG_SIGUSR2_ACTION=y
+CONFIG_SPI=y
+CONFIG_STACK_COLORATION=y
+CONFIG_START_DAY=30
+CONFIG_START_MONTH=11
+CONFIG_STDIO_BUFFER_SIZE=32
+CONFIG_STM32H7_BKPSRAM=y
+CONFIG_STM32H7_DMA1=y
+CONFIG_STM32H7_OTGFS=y
+CONFIG_STM32H7_PROGMEM=y
+CONFIG_STM32H7_SERIAL_DISABLE_REORDERING=y
+CONFIG_STM32H7_TIM1=y
+CONFIG_STM32H7_USART1=y
+CONFIG_SYSTEMTICK_HOOK=y
+CONFIG_SYSTEM_CDCACM=y
+CONFIG_TASK_NAME_SIZE=24
+CONFIG_TTY_SIGINT=y
+CONFIG_TTY_SIGINT_CHAR=0x03
+CONFIG_TTY_SIGTSTP=y
+CONFIG_USART1_RXBUFSIZE=600
+CONFIG_USART1_TXBUFSIZE=300
+CONFIG_USBDEV=y
+CONFIG_USBDEV_BUSPOWERED=y
+CONFIG_USBDEV_MAXPOWER=500
+CONFIG_USEC_PER_TICK=1000
+CONFIG_USERMAIN_STACKSIZE=2944
+CONFIG_USER_ENTRYPOINT="bootloader_main"