House Ambience

Set your house ambience in accordance to the ambient temperature around you using simple devices in 5 steps !

Pre-requisites

• Hardware

  • Arduino Uno or any other equivalent board
  • 5v Power supply
  • 3 Male-to-male Jumper Cables
  • 3 Male-to-female Jumper Cables
  • WS281B LED Strip
  • DHT11 or newer temperature sensor
  • Breadboard (Optional)

• Software

  • Arduino IDE
  • Library : FastLED (not by AdaFruit) & Unified Sensor by AdaFruit (howTo)

Usage

Step 1 : Open main.ino on your Arduino IDE
Step 2 : Install "FastLED" & "Unified Sensors" by AdaFruit
Step 3 : Enter the number of LEDs on your strip on the 4th line (You can change data pins according to your prefrence)
Step 4 : Select the right Com port via 'Tools'
Step 5 : Make the right connections (Check figure below)
Step 5 : Hit "Upload"

Note : After use disconnect the power supply jumper cable to LED Strip & Sensor to avoid any unwanted issues