Adding TraktPlexSync.service as a service under debian. Help #2030
-
So i installed (successfully) a program called "TraktPlexSync" After installation you need to run the command
to start the program and do what it does. The Documentation als says I can run a systemd service to start the command plextraktsync watch automatically during every boot. so I did:
and added the code from the Documentation
and finalized it with
then I went into the
into the services tab and "add" the PlexTraktSync (without .service) and turned everything on. but State stucks on "activating" Status Output: so I did a reboot and hoped I would not need to type
and it would run/start automatically....it did not. what am I doing wrong. did I read the Documentation wrong? Edit: I did not do this step: since I am not understanding what this means/does. May this be the culprit? Edit 2: here is what I get out if I check out the status:
gives me:
I just posted here 5 counts. it goes up to 88 |
Beta Was this translation helpful? Give feedback.
Replies: 1 comment
-
ok it works. that's the right code:
then
|
Beta Was this translation helpful? Give feedback.
ok it works. that's the right code:
then