-
Notifications
You must be signed in to change notification settings - Fork 20
WiFi DaynaPORT Ethernet emulation
- A ZuluSCSI Pico or ZuluSCSI Pico Slim, paired with a Pico W is required to utilize SCSI Ethernet emulation.
- A Macintosh computer running System 6 or later.
- Either OpenTransport or MacTCP.
OpenTransport is recommended for machines running System 7.1 and later, OpenTransport requires a 68030 or greater (including PowerPC) CPU, as well as 5MB of RAM, minimum. If your machine is not equipped with the above prerequisites, you must use MacTCP, which does not support DHCP.
TCP throughput in a best-case scenario, with a relatively fast machine, can read ~120 kilobytes/sec, but on slower machines, you should expect to see much lower throughputs, usually less than dial-up speed (40-50 kilobytes/sec)
To enable a DaynaPORT SCSI Ethernet device, create an empty file on your SD card named "NEx.img", where x is the desired SCSI ID.
The Wi-Fi SSID and passphrase should be defined in your zuluscsi.ini file, using the following syntax:
[SCSI]
WiFiSSID=MyWiFi
WiFiPassword=pass123
A MAC address is automatically generated by the firmware, but if you want to specify a MAC address, you can add WiFiMACAddress=CA:FE:DE:AD:BE:EF to your zuluscsi.ini file.
Under classic Mac OS, you will need to use either MacTCP or OpenTransport. Note that MacTCP does not support DHCP, so you will need to assign your own IP address within System 6/7. Additionally, you must install the DaynaPORT SCSI/Link driver, which can be, which can be downloaded from archive.org