Skip to content

Sample project to connect XENSIV™ sensor kit using Optiga secure element to IoTConnect.

Notifications You must be signed in to change notification settings

avnet-iotconnect/avnet-iotc-mtb-xensiv-example

Repository files navigation

About

Avnet IoTConnect Optiga and XENSIV™ project example for Infineon's ModusToolbox IDE and framework.

This code is based on the mtb-example-optiga-mqtt-client project and uses optiga_trust_helpers files.

Dependencies

The project uses the following dependent projects:

Supported Toolchains (make variable 'TOOLCHAIN')

  • GNU Arm® Embedded Compiler (GCC_ARM) - Default value of TOOLCHAIN

Supported Boards

The code has been developed and tested with MTB 3.2, with Eclipse, and the boards below: XENSIV™ KIT CSK PASCO2.

The kit contains the main MCU board with Optiga Secure Element along with the PAS CO2 sensor board that needs to be connected to the main board. This project will compile and run with or without the PAS CO2 board attached to the MCU.

Instructions

  • To evaluate this kit with a pre-compiled binary, refer to the QUICKSTART document.
  • If developing code with ModusToolbox, refer to the DEVELOPER_GUIDE document.