Simple holiday lights ESP8266 firmware with 20+ effects directly controllable from Domoticz. Number of LEDs per strip is configurable via MQTT message as is the type of LEDs used. Supports multiple zones (on multiple pins; max: 6) and up to 9 sections in each zone. Basic Boblight support on zone 0. Also supports Domoticz RGBW Switch type natively.
- 20+ LED effects (
- Set-up on first use / configure via MQTT/web server
- Uses WiFi Manager for initial configuration
- Change LED type & number of LEDs via MQTT message or embedded web interface
- basic Boblight support (works with Kodi)
- Restart and/or reset ESP to initial state via MQTT message
- Supports OTA updates
- Supports: WS2801, WS2811 and WS2812B LED strips
- Supports native Domoticz control (virtual selector switch) via MQTT
- Use GPIO14 (clock) and GPIO12 (data)
only for zone 0 & SPI based chip - Use GPIO 0,4,2,5,15,13 pins for non-SPI based chips (3-wire pixels WS2812/WS2811)
- Use only zones 0 and 1 for WS2811 pixels
- Use 64k SPIFFS on ESP01 if possible (for OTA updates via Arduino IDE)
- Configure via embedded web server
- Configure via MQTT message:
- LEDstrip/led-xxxxxx/set/zones [{JSON}]
zone 0 configuration in JSON format- {JSON} = { "zones":[{"ledtype":"WSxxxx", "leds":50, "sections":"0,25"},{"ledtype":...}] }
- "ledtype" : [WS2801|WS2811|WS2812]
LED strip type - "leds" : [#]
# of LEDs in zone 0 - "sections" : [0,#,...]
section's start delimited by comma
- LEDstrip/led-xxxxxx/set/effect [#]
# of effect - LEDstrip/led-xxxxxx/set/idx [#]
# of Domoticz virtual switch idx - LEDstrip/led-xxxxxx/set/hue [#]
set Hue - LEDstrip/led-xxxxxx/set/brightness [#]
global brightness control - LEDstrip/led-xxxxxx/command/restart
- LEDstrip/led-xxxxxx/command/reset [1]
factory reset
- LEDstrip/led-xxxxxx/set/zones [{JSON}]
- In Domoticz create a virtual Selector Switch, with options for each effect
- Due to ESP8266 HW limitations and speed of LED updates it is only possible to drive about 400-450 LEDs