-
IDE: Arduino IDE v.2.3.2 I created a script for ESP32C6 to send data from a pressure switch via Zigbee, and it worked without any problems until now. I wanted to update the script and took the opportunity to update the libraries as well. However, after updating to version 3.0.3 (of course I modified the script to make it compatible), the connection is successful, but after a few seconds I no longer receive data from the ESP. Even if I try to reboot with the reset button, the ESP can no longer connect to my Gateway. Another problem I noticed is that the ESP starts to overheat significantly, which was not the case with the old version. I tried the Zigbee Temperature Sensor example, but it gives me the same problem. If I go back to the old version it works again. Do you have any ideas on what the problem could be? I think the problem is the ESP card too old. |
Beta Was this translation helpful? Give feedback.
Replies: 3 comments 3 replies
-
@P-R-O-C-H-Y PTAL |
Beta Was this translation helpful? Give feedback.
-
Hello @MaXeN9818, I have ordered the SONOFF Zigbee gateway so I will test it. Last time I run the examples ED(esp32c6) and COORDINATOR(esp32h2) all worked fine. As for now we are just providing the Zigbee libraries without any wrapper, can you please open an issue in the ESP-ZIGBEE-SDK repository and ping me also there? Thank you |
Beta Was this translation helpful? Give feedback.
-
Sorry if this took a while. Thank you |
Beta Was this translation helpful? Give feedback.
Sorry if this took a while.
The disconnection problem has not occurred again and now everything seems stable.
I simply flashed the same firmware on the USB dongle and now it seems to work without problems
Thank you