-
-
Notifications
You must be signed in to change notification settings - Fork 763
How to Reset Hiddify panel to default
In this article, we are going to teach how to raw the Hiddify panel (complete reset of the panel and database) similar to the initial installation. If you intend to return the Hiddify panel to its initial settings, this tutorial is prepared for you. Follow these steps to the end.
-
To begin, first SSH into your server.
-
Then, by using the combination keys
ctrl+c
or selecting theCancel
button, close the Hidیify menu to access the terminal (command line environment) of your server. -
If after performing these steps, the Hiddify menu is still displayed to you, type the word
clear
and press enter.
It should be mentioned here that if you need to backup your panel, make a backup of the settings-backup before proceeding.
- Then enter this command in the terminal of your server to completely delete the current database:
rm -rf /opt/hiddify-config/hiddifypanel/hiddifypanel.db
- Then open the menu again using the following command:
bash /opt/hiddify-config/menu.sh
- And select
Reinstall
option from the Hiddify menu and wait for the panel to be reinstalled. - After finishing, you can access the new panel and configure it using the displayed admin links.
In this method, after the re-installation is finished, the panel will be completely retested and similar to the initial installation.
If after entering the subscription link you encounter the problem of reality or ping not working -1
go to Advanced settings
and set TLS
to 1.3
from the following path.
Settings > Option Setting > v2rayN settings > Enable Security Protocol TLS v1.3
and finally click Confirm
.
To improve the performance and also update the cores required by the program such as Xray, SingBox, go to the same path as mentioned.
Activate the Check for pre-release update
option and then update the kernels through the Check update
option.
- For this, you need to activate the
TunMode
option and it is necessary to use the Sing-box core. Therefore, on the main page of the program, download theSing-box core
using theCheck update
button.
- Then go to the following path.
Settings > Option Setting > TunMode settings
- Then enable the
Strict Route
option. - Set the
Stack
option toSystem
. - Now enable the
TunMode
button from the home screen.
Note: To activate the
TunMode
button, the program must be opened asRun as administrator
. Note: IfTunMode
does not work for you for any reason, set theStack
option ongvisor
If, despite using the Lite
or green profile prepared in the panel, you need to send the traffic of another site to the destination without going through the filter breaker, you can do it in two ways.
To do this, go to this path.
Settings > Option Setting > v2rayN settings > System proxy settings
Enter here the addresses you want not to pass through the app. between each address put ;
.
Note: Here use
xyz.com
instead ofhttps://xyz.com
.
To do this, go to the following path.
Settings > Routing setting
As you can see, by importing the Lite
or Green profile, the internal site traffic rules have been added here. If you want to do this mode manually and place your desired sites,
- To do this, turn off
Enable advanced function
option. - Then select the
direct domain or IP
option. - You can enter your desired domain. Use
,
to separate multiple sites. - You can block your desired domains through the
block domain or ip
option.