Skip to content

AAT Automatic Antenna Tracker

Pawel Spychalski (DzikuVx) edited this page Sep 21, 2022 · 2 revisions

Since release 3.0, INAV directly supports embedded video telemetry data to drive the VirtualPilot Sentinel antenna tracker.

This enables the use of directional higher gain antennas to maintain higher quality video in all directions, provide the ability to use lower video transmission power or increase the maximum reception distance over traditional omnidirectional antennas. The AAT provides the benefit of maintaining a more accurate direction over manually mounted antennas without the concern of the aircraft moving outside of the antenna’s dominant reception area.


Configuring - iNAV 3.0 onwards (embedded support)

  • Requires minimum of INAV 3.0 and fonts installed
  • Enable AAT telemetry in the cli: set osd_telemetry = ON

Configuring - iNAV earlier versions

Testing

As telemetry data is not normally visible, the telemetry data can be viewed on the OSD using a cli command:

  • Enable AAT telemetry with second test line in the cli: set osd_telemetry = TEST
  • Remember to change it back when finished: set osd_telemetry = ON (FC restart required)

Description of operation

  • iNAV knows its home launch position, current position and altitude
  • iNAV can calculate the pan and tilt information required by the antenna tracker
  • The data is sent using video telemetry over an analogue signal
  • The video telemetry is sent on OSD row 0 with only pixel line 0 used
  • 30 bits of information are sent in each video frame which includes tilt angle, pan angle and error validation check
  • Two font characters are used to represent a binary 0 or 1

Positives of using this telemetry method:

  • Simple and reliable
  • No hardware modules or extra wiring on aircraft
  • Supports all RC TX - not limited to TX with telemetry
  • Does not require unreliable bluetooth / wifi connections to tracker
  • Not impacted by 2.4G RC /Video
  • Ultra-fast position updating – up to 30 hz
  • Low size packet means higher tracking success rate in poor signal conditions

Negatives of using this telemetry method:

  • Tracking data may be recorded by some DVR. Not usually visible in goggles / monitor
  • The first row of OSD display becomes unavailable for OSD. However, this row is not usually fully visible
  • This does not use tracker GPS location – so cannot be used in a moving vehicle

In the visualisation video below, you can see how the telemetry data is sent. This is a test mode as it is not usually visible in FPV goggles / recordings, however notice how the real telemetry line on pixel row zero is not visible.

Telemetry visualisation capture


Sentinel AAT for use with iNAV

Further information on the Sentinel AAT is available by clicking on the image:

Sentinel AAT

WIKI TOPICS

Wiki Home Page

INAV Version Release Notes

7.1.0 Release Notes
7.0.0 Release Notes
6.0.0 Release Notes
5.1 Release notes
5.0.0 Release Notes
4.1.0 Release Notes
4.0.0 Release Notes
3.0.0 Release Notes
2.6.0 Release Notes
2.5.1 Release notes
2.5.0 Release Notes
2.4.0 Release Notes
2.3.0 Release Notes
2.2.1 Release Notes
2.2.0 Release Notes
2.1.0 Release Notes
2.0.0 Release Notes
1.9.1 Release notes
1.9.0 Release notes
1.8.0 Release notes
1.7.3 Release notes
Older Release Notes

QUICK START GUIDES

Getting started with iNav
Fixed Wing Guide
Howto: CC3D flight controller, minimOSD , telemetry and GPS for fixed wing
Howto: CC3D flight controller, minimOSD, GPS and LTM telemetry for fixed wing
INAV for BetaFlight users
launch mode
Multirotor guide
YouTube video guides
DevDocs Getting Started.md
DevDocs INAV_Fixed_Wing_Setup_Guide.pdf
DevDocs Safety.md

Connecting to INAV

Bluetooth setup to configure your flight controller
DevDocs Wireless Connections (BLE, TCP and UDP).md\

Flashing and Upgrading

Boards, Targets and PWM allocations
Upgrading from an older version of INAV to the current version
DevDocs Installation.md
DevDocs USB Flashing.md

Setup Tab
Live 3D Graphic & Pre-Arming Checks

Calibration Tab
Accelerometer, Compass, & Optic Flow Calibration

Alignment Tool Tab
Adjust mount angle of FC & Compass

Ports Tab
Map Devices to UART Serial Ports

Receiver Tab
Set protocol and channel mapping

Mixer

Mixer Tab
Custom mixes for exotic setups
DevDocs Mixer.md

Outputs

DevDocs ESC and servo outputs.md
DevDocs Servo.md

Modes

Modes
Navigation modes
Navigation Mode: Return to Home
DevDocs Controls.md
DevDocs INAV_Modes.pdf
DevDocs Navigation.md

Configuration

Sensor auto detect and hardware failure detection

Failsafe

Failsafe
DevDocs Failsafe.md

PID Tuning

PID Attenuation and scaling
Fixed Wing Tuning for INAV 3.0
Tune INAV PIFF controller for fixedwing
DevDocs Autotune - fixedwing.md
DevDocs INAV PID Controller.md
DevDocs INAV_Wing_Tuning_Masterclass.pdf
DevDocs PID tuning.md
DevDocs Profiles.md

GPS

GPS and Compass setup
GPS Failsafe and Glitch Protection

OSD and VTx

DevDocs Betaflight 4.3 compatible OSD.md
OSD custom messages
OSD Hud and ESP32 radars
DevDocs OSD.md
DevDocs VTx.md

LED Strip

DevDocs LedStrip.md

ADVANCED

Advanced Tuning

Fixed Wing Autolaunch
DevDocs INAV_Autolaunch.pdf

Programming

DevDocs Programming Framework.md

Adjustments

DevDocs Inflight Adjustments.md

Mission Control

iNavFlight Missions
DevDocs Safehomes.md

Tethered Logging

Log when FC is connected via USB

Blackbox

DevDocs Blackbox.md
INAV blackbox variables
DevDocs USB_Mass_Storage_(MSC)_mode.md

CLI

iNav CLI variables
DevDocs Cli.md
DevDocs Settings.md

VTOL

DevDocs MixerProfile.md
DevDocs VTOL.md

TROUBLESHOOTING

"Something" is disabled Reasons
Blinkenlights
Pixel OSD FAQs
TROUBLESHOOTING
Why do I have limited servo throw in my airplane

ADTL TOPICS, FEATURES, DEV INFO

AAT Automatic Antenna Tracker
Building custom firmware
Default values for different type of aircrafts
Features safe to add and remove to fit your needs.
Developer info
INAV MSP frames changelog
INAV Remote Management, Control and Telemetry
Lightweight Telemetry (LTM)
Making a new Virtualbox to make your own INAV
MSP Navigation Messages
MSP V2
OrangeRX LRS RX and OMNIBUS F4
Rate Dynamics
Target and Sensor support
UAV Interconnect Bus
Ublox 3.01 firmware and Galileo
DevDocs 1wire.md
DevDocs ADSB.md
DevDocs Battery.md
DevDocs Buzzer.md
DevDocs Channel forwarding.md
DevDocs Display.md
DevDocs Fixed Wing Landing.md
DevDocs GPS_fix_estimation.md
DevDocs LED pin PWM.md
DevDocs Lights.md
DevDocs OSD Joystick.md
DevDocs Servo Gimbal.md
DevDocs Temperature sensors.md

OLD LEGACY INFO

Supported boards
DevDocs Boards.md
Legacy Mixers
Legacy target ChebuzzF3
Legacy target Colibri RACE
Legacy target Motolab
Legacy target Omnibus F3
Legacy target Paris Air Hero 32
Legacy target Paris Air Hero 32 F3
Legacy target Sparky
Legacy target SPRacingF3
Legacy target SPRacingF3EVO
Legacy target SPRacingF3EVO_1SS
DevDocs Configuration.md
Request form new PRESET
DevDocs Introduction.md
Welcome to INAV, useful links and products
iNav Telemetry
DevDocs Rangefinder.md
DevDocs Rssi.md
DevDocs Runcam device.md
DevDocs Serial.md
DevDocs Telemetry.md
DevDocs Rx.md
DevDocs Spektrum bind.md

Clone this wiki locally