v3.0

Add self-reset code to prevent freezing if USB suspends or goes down.

GHETT-iO Version 2.0

* Switched to Direct Memory Access and ISRs for minimum latency

* Added option to see firmware version of current GHETT-iO

* Further increased debounce poll rate

* Address issue where device resets when used in a pad

* Change pin configuration to support future accessories

GHETT-iO v1.1

This release is not recommended for production use.

Added software-initiated bootloader support (so firmware can be updated in the future without removing the device from the pads.

Increased the debounce frequency so that it's less likely to trigger on fast runs.

Firmware-Upgrade.zip contains the firmware update utility. If you are not yet on firmware 1.1, you will need to use PSoC Programmer and the programming board (the small board that accompanied your GHETT-iO order) to update to 1.1 before this utility works. This should be the only time you need to do this.

GHETT-iO v1.0 firmware

Release 1.0 of the GHETT-iO firmware. Program using the bootloader, or PSoC programmer.