Open source multi-target carousel controller for Neccera PLD System
Created by: The M3 Learning Group
All designs and code by: Ryan Forelli
- 1x Custom PCB
- 2x A4988 stepper motor drivers
- 1x ATmega328P AVR microcontroller
- 5x 5mm DIP LEDs
- 1x Pin header set
- 1x Molex 6 Circuit Wire Connector
- 1x through hole pushbutton
- 1x 16 MHz crystal oscillator
- 2x 22pF ceramic capacitors
- 1x 10uF electrolytic capacitor
- 1x 100uF electrolytic capacitor
- 1x 10k through-hole resistor
- 1x Assorted single-core jumper wires
- 1x Standoffs (optional)
- 1x Custom back plate (optional)
- 1x USB to TTL Adapter
- Supply PCB with 5V supply from USB to TTL Adapter
- Supply Stepper motor controller with 24V from Multi-Target Carousel Controller or other source
- Only four Molex connector pins are used. Use PCB schematic for reference when wiring connectors to PCB
- Power PLD Controller module
- Open LabVIEW pldsyscontrol.exe and run the Virtual Instrument (VI)
- Select COM port
- Home raster motor (does not home to a specific target)
- Select target and begin use