BDsensor is the first distance sensor that can work with 3D printer and do fast bed leveling and adjust z axis in real time. it can measure the bed distance at any point in real time without moving the z axis up and down.
Faster leveling, realtime compensation, high accuracy.
-
No need to do probe points before every print, it will be automatically compensated for based on actual distance in real time.
-
You can do bed mesh leveling like a normal proximity sensor but much faster with this BDsensor.
-
Easy manual bed level adjustment thanks to ability to display the live sensor distance measurement on your screen.
Sensor type: inductive, eddy, can only measure the metal plate.
Range: 4mm (for different metal the range should be different, the normal pei steel plate is 4mm, but aluminum is about 2mm)
- It can connect to most motherboards or GPIOs on the RaspberryPi
- Easy to install: small and light; can be installed anywhere, even surrounding metal above
- Support Can bus module
- Support high temperature chamber(120C) with the long cable probe BDsensorM.
| . | hardware | firmware |
|---|---|---|
| 2022.6 | BDsensor VA, V1.0 | V1.0 |
| 2023.4 | BDsensor VB, V1.1, the connector was changed | V1.1, support self reboot |
| 2023.11 | BDsensor VB, V1.3, Upgrade the MCU to STM32 | V1.2, for stm32 |
| 2024.2 | V1.2c, Support nozzle collision sensing | |
| 2024.3 | BDsensorM V1.0 | V1.2c |
| 2024.7 | BDsensorM V1.1 | V1.2c, Pins order are changed in EXP1 connector |
| . | Marlin | Klipper |
|---|---|---|
| Real Time leveling(beta) | ✔️ | ✔️ |
| Fast bed mesh | ✔️ | ✔️ |
| Fast bed mesh(No toolhead stop) | ✔️ | ✔️ |
| Distance display | ✔️ | ✔️ |
| Can bus toolhead | No | ✔️ |
| standby mode automatic while printing | ✔️ | ✔️ |
| KAMP Adaptive Meshing & Purging | No | ✔️ |
| nozzle collision sensing | Detail✔️ | ✔️ |
- Auto z offset calibration.
- Overcome the temperature drift. The temperature drift will only change the z_offset, it will rise or low the whole bed mesh, but does not change the bed mesh with this BDsensor. that means the bed mesh is the same even with different temperature.
- Repeatability: +/-0.005mm
- No external hardware and easy to adjust
- For High temperature chamber up to 120C
- The lightest probe, 1.5g
Document : WiKi
Mount STL: BLtouch_Compatible | VzBoT | Stealthburner Voron
https://www.facebook.com/groups/380795976169477
pandapi3d.com , elecrow , 淘宝店
