Skip to content

Emulate DCF77 time signal on Flipper Zero using the RFID antenna and the A4 GPIO pin

License

Notifications You must be signed in to change notification settings

mdaskalov/dcf77-clock-sync

Folders and files

NameName
Last commit message
Last commit date

Latest commit

 

History

28 Commits
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 

Repository files navigation

Flipper-Zero DCF77 Clock Sync

Emulates the DCF77 time signal on the RFID antenna and on GPIO A4 pin.

Uses PWM with frequency of 77.5 kHz on the GPIO pin to simulate the signal.

Usage

Normally the clock gets syncrhonized in two to five minutes depending on the signal strength.

The OK button changes the transmitted signal between CET and CEST (dst) time.

Antenna

The RFID antenna wokrs best at distances of up to 50cm. The signal gets recognized in few seconds.

When using the GPIO, best results are achieved if you connect a ferrite antenna over 330 ohm resistor and a capactior to ground.

It also works with analog beeper or small in-ear headphone connected to the GPIO pin.

About

Emulate DCF77 time signal on Flipper Zero using the RFID antenna and the A4 GPIO pin

Resources

License

Stars

Watchers

Forks

Packages

No packages published

Languages