Ender 3 V2 with Creality Sprite Pro Extruder printing problems #1341
-
|
Having problems with my Creality Sprite Pro extruder on Ender 3 V2 w/ 4.2.7 board. I used the configurator correctly (I'm pretty sure), but when trying to print, I can't even get a first layer down, just a bunch of stringing/balling up at the nozzle. I've correctly set my z-offset, but what else might I be missing? Thanks for any help!
|
Beta Was this translation helpful? Give feedback.
Replies: 2 comments
-
|
After reading some stuff online, I adjusted my e-steps, which left me at a value somewhere around 425. I had originally thought this was quite high, but Creality actually recommends a value of 424.9 for the Sprite extruder, so this value is correct. It may be worth adjusting the Configurator (https://github.com/mriscoc/Special_Configurations) to use this setting as default when selecting T13, as this corresponds to the Sprite Extruder Pro temperature sensor. |
Beta Was this translation helpful? Give feedback.
After reading some stuff online, I adjusted my e-steps, which left me at a value somewhere around 425. I had originally thought this was quite high, but Creality actually recommends a value of 424.9 for the Sprite extruder, so this value is correct. It may be worth adjusting the Configurator (https://github.com/mriscoc/Special_Configurations) to use this setting as default when selecting T13, as this corresponds to the Sprite Extruder Pro temperature sensor.