-
|
I'm running a direct drive and set my retraction to 1mm in Cura. I noticed in the Tune menu during a print that I could tune the retraction. I also noticed it said my current retraction was 5mm, even though it was set to 1mm in Cura. Do you know which retraction setting the print is actually using? |
Beta Was this translation helpful? Give feedback.
Replies: 1 comment
-
|
The retraction settings in "Tune" and "Filament Settings" menus are for an advanced feature called Firmware Retraction that allows you to tunning the best retraction for improve quality and print speed. You must to configure your slicer according to the Wiki to enable that feature. |
Beta Was this translation helpful? Give feedback.
The retraction settings in "Tune" and "Filament Settings" menus are for an advanced feature called Firmware Retraction that allows you to tunning the best retraction for improve quality and print speed. You must to configure your slicer according to the Wiki to enable that feature.