spower sp05 is the first flagship power bank created by panglikesheep18, it features detachable battery and an external XT30 connector (stock) for powering hobby charger, the battery uses 4 cells with BMS on it.
the battery can be charged by a hobby charger allowing fast(er) charging , the battery (pack) defaults 4 cell 5500mAh batteries connected in series with a BMS attached, and can be shrinked down to 5000mAh each or increased to 6000mAh each natively .
Warning: the project you want to make contains lithium polymer battery, which will explode with or without user interaction (i.e. heating the pads for too long, bending, puncturing or crushing during assembly, short circuit on internal circuit or through external inputs or overloading the battery), I (panglikesheep18) don't have responsibility for causing explosion due to user errors, please be certin with building one. Building your own at your own risk!!
Print them in PETG or ABS if the file doesn't start with anything special
Print them in transparent (natural) PETG filament if the file starts with [t]
Print them in TPU95A if the file starts with [s]
Recommended print configuration is 0.2mm layer height, 1mm wall thickness, 1mm top thickness, 1mm bottom thickness (1mm top / bottom thickness), 40% infill percentage (infills higher than 40% have no major durability improvments), any infill type is OK, no slicer supports are required, PETG, ABS, and TPU95A for xt30cover is recommended.
