Khala Connect everything!
Based on n2n, we add UDP punching process make it is possible to make a UDP hole between NAT3 <-> NAT4.
We would not have any plan for further development and support, good luck :)
Required following libraries:
- libjson-c
- libcurl
These libraries should be installed before start compiling, compile commands as following:
sudo apt-get install libcurl4-openssl-dev -y
sudo apt-get install libjson-c-dev -y
cmake ./
make
Parameters introduction (参数介绍):
-f: supernode run in foreground (如果开启这个选项SN将会运行在前台)-v: make more verbose (调整LOG等级，每多一个v，LOG等级提高1级)-s: specified url used to verify community and password from edge（默认不配置即可）-p: specified local port, default is 7654 (指定SN的端口，默认端口是7654)
Example:
sudo supernode -p 7654
Parameters introduction (参数介绍):
-c: community name edge belongs to (节点要加入/创建的community名称)-k: encryption key (密码)-a: interface address and optional CIDR subnet (ip地址 eg. static:10.110.0.1)-f: edge run in foreground (如果开启这个选项edge将会运行在前台)-l: supernode ip address or name, and port (指定SN的地址与端口 eg. supernode.net:7654)-r: enable packet forwarding through community (允许报文通过community转发)-d: TAP device name (创建的设备名)-A: choose a cipher for payload encryption (加密算法选择使用ChaCha20 -A4)
Example:
sudo edge -c mycmn -k mypaswd -a 10.110.10.1 -l supernode.net:7654 -r -d edge0 -A4