v2.0.1

• Minor improvements to printer.cfg
• Minor Orca profile improvements, improved consistency between profiles

Supported Printers

These printers are currently supported

• Adventurer 3/Lite/Pro (printers with 2209 drivers need to edit config)

• MonoPrice Voxel

• (Unknown) Arçelik PT1000

• (Unknown) Bresser Rex

Currently Unsupported

These are on the roadmap to be supported in a later release

• Any printer with N32G455 microcontroller
• Adventurer 4/Lite/Pro
• MonoPrice Voxel Pro
• Adventurer 3 Pro 2

Possible Future Support

• Adventurer 5M/Pro
• Creator 3/Pro
• Guider IIs
• Finder 3

If you have an unsupported FlashForge printer (or rebrand), open a Pull Request if you would like to contribute, or open an Issue for assistance.

v2.0

• Massively improved printer config
• Fixed Z and E stepper driver UART muxing (thank you, @hw-lunemann!)
• Better guide with simplified wiring, fewer required parts, Pi and MCU setup commands, etc.
• Added basic Orca Slicer profile, will expand on later.

Supported Printers

These printers are currently supported

• Adventurer 3/Lite/Pro (printers with 2209 drivers need to edit config)

• MonoPrice Voxel

• (Unknown) Arçelik PT1000

• (Unknown) Bresser Rex

Currently Unsupported

These are on the roadmap to be supported in a later release

• Any printer with N32G455 microcontroller
• Adventurer 4/Lite/Pro
• MonoPrice Voxel Pro
• Adventurer 3 Pro 2

Possible Future Support

• Adventurer 5M/Pro
• Creator 3/Pro
• Guider IIs
• Finder 3

If you have an unsupported FlashForge printer (or rebrand), open a Pull Request if you would like to contribute, or open an Issue for assistance.