Included is a demo project that flashes a led connected to PC13 (ready to run on an STM32 Mini Dev Board STM32F103C8T6).
If you have an J-Link programmer you are allmost ready to play with your device.
Configuration is done through these files:
makefile build options (optimization, etc)
stm32.ld target memory size and type
stm32f10x_conf.h firmware library configuration
stm32f10x_it.c interrupt handlers
jtag/flash.cfg OpenOCD configuration (JTAG dongle, etc)
sudo apt-get install libusb-dev
git clone git://git.code.sf.net/p/openocd/code openocd-code
cd openocd-code
git checkout tags/v0.9.0
./configure --enable-maintainer-mode --disable-werror --enable-jlink
make
sudo make install
Edit file jtag/openocd.conf and chage transport select jtag or transport select swd according to your board connector
Install gcc cross compiler
sudo apt install gcc-arm-none-eabi
Edit file jtag/openocd.conf and chage transport select jtag or transport select swd according to your board connector
Run command to build and flash the device
make flash
$ openocd -f jtag/openocd.cfg -c "program bootloader/generic_boot20_pc13.bin 0x08000000 verify reset exit"
Bootloader binary from : https://github.com/rogerclarkmelbourne/STM32duino-bootloader
In order to enter in perpetual bootloader mode you need to put PC14 to high level imediately after hiting reset. When the slow blinks continue on forever, that means perpetual bootloader mode is active.
$ dmesg
[ 2745.356014] usb 6-1: new full-speed USB device number 49 using uhci_hcd
[ 2745.523034] usb 6-1: New USB device found, idVendor=1eaf, idProduct=0003
[ 2745.523038] usb 6-1: New USB device strings: Mfr=1, Product=2, SerialNumber=3
[ 2745.523040] usb 6-1: Product: Maple 003
[ 2745.523043] usb 6-1: Manufacturer: LeafLabs
[ 2745.523045] usb 6-1: SerialNumber: LLM 003
