ftdi-nand-flash-tool

NAND flash reader/programmer using a FTDI FT2232 IC in bit-bang mode

General

This flash tool can be used to read (dump) and program parallel x8 bare NAND flash chips. The target used was a TSOP48 Toshiba 256MiB chip, and the code is reasonably tied to the specs of this chip but should be very easily adapted (or made more generic) for any other parallel NAND chip.

Note: big-banging over USB is slow....

For a "real" tool to work with raw flash, see the dumpflash project. It uses the same FTDI FT2232 chip in "Host bus emulation mode" which is much faster but was giving me trouble.

This tool is a good start learning about the flash protocol without any magic done by the FDTI chip. It is very raw and will most likely require some good tweaking to work with any chip other than the expected Toshiba chip.

Usage

Dump the whole flash using:

./flash-tool -f output.bin

Reprogram an empty chip (after erasing first) with:

./flash-tool -p output.bin

Erase a whole chip (note: will obliterate factory bad blocks, BAD!):

./flash-tool -E

Hardware and Wiring

The NAND flash reader / programmer can be put together easily using a FT2232 breakout board (for example, a DLP-2232H that is breadboard friendly) and a TSOP48->DIP adapter.

These are the main signals to be connected:

FT2232	NAND	Signal Name
ADBUS0	IO0	Data bus bit 0
ADBUS1	IO1	Data bus bit 1
ADBUS2	IO2	Data bus bit 2
ADBUS3	IO3	Data bus bit 3
ADBUS4	IO4	Data bus bit 4
ADBUS5	IO5	Data bus bit 5
ADBUS6	IO6	Data bus bit 6
ADBUS7	IO7	Data bus bit 7
BDBUS0	CLE	Command Latch Enable
BDBUS1	ALE	Address Latch Enable
BDBUS2	CE#	Chip Enable (Low)
BDBUS3	WE#	Write Enable (Low)
BDBUS4	RE#	Read Enable (Low)
BDBUS5	WP#	Write Protect (Low)
BDBUS6	RY/BY#	READY / BUSY (Low)

Typically the Ready/Busy signal (BDBUS6) will have to be pulled up with a 10K resistor to 3V3.

The GND and 3V3 power pins (typically a pair on each side of the TSOP48 chip) will also have to be connected.

Credits

Forked from ftdi-nand-flash-reader y maehw.