forked from krisstakos/Hoverboard-Firmware-Hack-Gen2.1
-
Notifications
You must be signed in to change notification settings - Fork 29
Control Methods
reed-dan edited this page Feb 15, 2024
·
6 revisions
#define REMOTE_DUMMY
- This will spin the motor forward and backward with no remote control, and can be used to verify you have everything hooked up correctly.
#define REMOTE_UART
- This will allow you to us a Aduino Nano or ESP32 and uart on 19200 baud rate to control your motor.
#define REMOTE_UARTBUS
-
Similar to Remote UART, but you can simolatinously control multiple motors with an Arduino Nano or ESP32 using the 19200 baud rate. This method requires the use of diodes on the TX line of each motherboard. This prevents the communication from the 1 hoverboard motherboard to the other, and forces the TX line to only go to the Remote UART device.
-
You only need to connect one ESP/UART device, the picture is intended to show 2 hookup options.
#define REMOTE_CRSF // https://github.com/RoboDurden/Hoverboard-Firmware-Hack-Gen2.x/issues/26
SWD Flashers
SWD Flashing
- Flash via Keil
- Flash via PYocd
- Flash via StLink Utilities
- Flash via Stm32 Cube Programmer
- Flash via st-flash.exe
Submit New Layout